- Will any coax cable work for Internet?
- Is coaxial cable balanced or unbalanced?
- Can a coax cable go bad?
- Do I need a balun on my TV antenna?
- What does a coaxial cable plug into?
- Is a dipole balanced or unbalanced?
- Why don t guitars use balanced cables?
- What is a balanced cable?
- How tight should coaxial cable be?
- What balun do I need for a dipole?
- Why is coaxial cable not working?
- Why is a coaxial cable needed?
- How long can you run coax cable without loss?
- What is a balanced antenna?
Will any coax cable work for Internet?
generally yes the cable modem prefers rg6 just like HD video does but it works on rg59 if that is all you have.
Make sure your splitters are rated for data some of the older splitters will cause your modem to not work well..
Is coaxial cable balanced or unbalanced?
In electrical engineering, an unbalanced line is a transmission line, often coaxial cable, whose conductors have unequal impedances with respect to ground; as opposed to a balanced line. Microstrip and single-wire lines are also unbalanced lines.
Can a coax cable go bad?
There are four things that damage a coaxial cable: physical, water, heat and connector. … Connector Damage – Connectors can go bad from constant use. The connect itself can be dislodged from the cable. Even oxidation can cause video quality issues.
Do I need a balun on my TV antenna?
3. Even today, no balun is needed, even with the 300-Ohm feed line. Of course, it could all be due to the manufacturers not wanting to change the production line to use coax instead of the twin lead. Now for the antenna test.
What does a coaxial cable plug into?
Coaxial Cable These common cables are great at keeping your TV signal strong. They connect either: From the wall or splitter to your TV Box. You may also use this to connect your TV to your TV Box, to some DVD players and VCRs, and to other similar devices.
Is a dipole balanced or unbalanced?
Antennas can be balanced or unbalanced. A balanced antenna is symmetrical about the feed point (e.g. a dipole) whereas an unbalanced antenna is not systematical about the feed point (e.g. a Windom). In the real world all antennas are unbalanced to some degree.
Why don t guitars use balanced cables?
The answer lies in balanced vs unbalanced cables. Without getting into the technical details, the main point to remember is that balanced cables cancel out noise and interference and unbalanced cables don’t. As an example, guitar cables are unbalanced and most microphone cables are balanced.
What is a balanced cable?
Balanced cables have three wires inside the plastic casing: two signal wires and a ground wire. The signal wires pass an identical audio signal through each wire, while the surrounding ground wire works the same as in unbalanced cables, shielding the signal wires from external electronic interference.
How tight should coaxial cable be?
Most folks will connect their coaxial cables just finger tight to their equipment, and that may not quite do it. With RG6 cables of any kind, you should always have a 7/16″ wrench handy. … You should be able to feel some resistance when you tighten with a wrench; don’t go past that point or you’ll break the connector.
What balun do I need for a dipole?
The overall length of the multi-band dipole antenna should be shorter than one-half wavelength as shown in Table 1. For best efficiency, ladder line feed and a good antenna tuner with balanced connections are required. The ideal balun is a 1:1 ratio DX Engineering special application tuner balun.
Why is coaxial cable not working?
Check your cable modem’s Ethernet and coaxial cable connections. Make sure the coaxial cable is tightly connected. If a computer is plugged into an Ethernet port, make sure that the cable is plugged in all the way on both ends. If you are using wireless, check that your wireless connection is functioning correctly.
Why is a coaxial cable needed?
Coaxial cable is used as a transmission line for radio frequency signals. Its applications include feedlines connecting radio transmitters and receivers to their antennas, computer network (e.g., Ethernet) connections, digital audio (S/PDIF), and distribution of cable television signals.
How long can you run coax cable without loss?
When it comes to signal loss over longer cable lengths, the basic rule of thumb is that a 50-foot cable can experience noticeable signal loss, and a 100-foot cable can drop as much as one-third of the original signal.
What is a balanced antenna?
A balanced antenna is one where the elements are fed and are of equal length on both sides such as a dipole antenna ( most but not in all cases).